• 首页本刊介绍编委会投稿须知审稿编辑流程期刊征订广告征订English
  • 选择皮肤:
谢业平,刘永泉,潘宝军.真实进气条件下发动机气动稳定性计算方法[J].航空动力学报,2019,(4):804~812
真实进气条件下发动机气动稳定性计算方法
Aerodynamic calculation method of engine stabilityunder actual inlet condition
投稿时间:2018-08-23  
DOI:10.13224/j.cnki.jasp.2019.04.009
中文关键词:  温度畸变  压力畸变  组合畸变  畸变图谱等效转换  子发动机
英文关键词:temperature distortion  pressure distortion  combined distortion  equivalent conversion of distortion contour maps  sub-engine
基金项目:
作者单位
谢业平 中国航空发动机集团有限公司 沈阳发动机研究所,沈阳 110015 
刘永泉 中国航空发动机集团有限公司 沈阳发动机研究所,沈阳 110015 
潘宝军 中国航空发动机集团有限公司 沈阳发动机研究所,沈阳 110015 
摘要点击次数: 189
全文下载次数: 298
中文摘要:
      基于平行压气机理论,采用非定常、二维、无黏的积分型欧拉方程,以蒸汽吸入试验中产生的温度和压力组合畸变为边界条件,开展真实进气条件下温度和压力组合畸变对发动机影响的计算方法研究。在保证畸变强度、高温区范围、低压区范围等特征不变的前提下,对畸变图谱进行规则化等效转换,同时协调温度和压力畸变图谱,使两者可以进行相互叠加计算。结果表明:当周向子发动机数量大于2时,子发动机数量对计算结果影响不大;组合畸变对风扇、压气机压比影响规律与单独的压力畸变相同;与试验的推力损失对比显示,对畸变图谱进行等效规则化转换,可以用于真实组合畸变的计算。
英文摘要:
      Based on the theory of parallel compressor, the calculation method of the influence of actual combined distortion on the engine was studied with the temperature and pressure distortion generated by the steam suction as boundary conditions. The unsteady two-dimensional inviscid integral Euler’s equations were used. While the distortion intensity, the high temperature range, and the low pressure range were kept the same, the regularized equivalent conversion of the distortion contour maps was performed. And the temperature and pressure distortion contour maps were coordinated, so that these two could be superimposed on each other. Results showed that when the number of circumferential sub-engines was greater than 2, the number of sub-engines had little effect on the calculation results. The influence of combined distortion on the fan and compressor pressure ratio was the same as the single pressure distortion. Compared with the experimental thrust loss, the equivalent regularization transformation of the distortion map can be used for the calculation of the actual combined distortion.
查看全文  查看/发表评论  下载PDF阅读器
关闭
.